Found loose connection at timer. Reinstalled loose connection. Unit is now working as intended no issues at this time

Order switch; ordrng 1 W11230930 (Switch)

re-installed loose access panel and insulation and checked operation. ck ok

Found loose connection at the dispenser unit checks ok

Unit repair was denied. Completing out document.

Found heater wire not making proper connection

Replaced open element on dryer. Operations are correct now ; used 1 279838 (Element) from stock

Error code for f7 e1 . Replaced actuator on unit operations are correct; used 1 W11481722 (Actuator) from stock

reattached loose heating element - tested working as normal

"Ran diagnostics, documented findings with techline. SR-7740362965 unit non repairable. Will need to refer back to extended warranty"

I replaced door switch from truck stock. Unit is not coming on.

unit needs suspension replacement ; ordrng 1 w11130362 (Suspension)

Found loose connection at control. Reinstalled loose connection. Unit is now working as intended no issues at this time

Need to order; ordrng 1 W11436967 (Door freezer)

Found faulty control part order ; ordrng 1 W11170319 (Control)

Found faulty thermistor and heater assembly part order ; ordrng 1 WP61006199 (Heater harness)

"Customer didnt know that she had to clean out the lint trap and has never done it since she has used the dryer and it had several inches of lint buildup, causing air restriction so her clothes wouldnt dry i told the customer to clean it to two loads because it will build up very thick like that if you dont empty it out"

Fixed hanging insulation.

SR# 7740352467 checked unit found aftermarket filter not in properly causing stoppage in water flow. Removed filter water filled properly.

"Checked unit to find customer has one fault code of f0e3 which she denies overloading unit and not causing to spin out her clothes,,she was informed all ops working as designed on arrival unit is getting cold and hot water with drain pump taking all water out of tub,,,unit is ok"

Check unit to find all operations working as design on arrival. Customer is working on his own refrigerator and wants ASI to back up what hes already messed up is OK.

Ran diagnostic with techline ordering Replacement Compressor and evaporator.; ordrng 1 W11582579 (Compressor) and 1 W11506619 (8/8 coupler) and 1 W11506635 (Charging tube) and 1 W11504445 (5/4 alm coupler) and 1 W11109499 (Drier) and 1 W11562258 (Evaporator) and 1 W11504419 (8-7 aluminum)

Replaced faulty pump and motor assembly. All unit functions now checked ok

Customer says unit isn't getting hot enough. Set calibration about 20 degrees. ARan oven temperature checked ok. Reported to techline

Ordering replacement Stainless door; ordrng 1 W10815669 (Stainless steel door)

Ran diagnostic adjusted burner caps and valve. All unit functions now checked ok

"Ran diagnostic, recorded fault code F6E6. Ordering replacement Slider; ordrng 1 W10734521 (Slider)"

Ran diagnostic with techline. Sr7740358822. Reported with safety. They will assisting with repair

"Ran diagnostic, cleared debri from vent. All functions checked ok at this time"

Checked unit suspension rods are going bad in the rear part of unit ; ordrng 1 W11130362 (Suspension rods)

Inspected oven and found no ignition Sent customer quote for DSI board Customer approved ; ordrng 1 WPW10511278 (DSI board)

Replaced panel

"Arrived at customer home to troubleshoot Began asking Mrs questions regarding the complaint and symptoms and when they began. Did this fridge come from a different address, normal questions related to troubleshooting I guess customer was getting upset unbeknownst to me regarding the questions but she did not say anything at firstI kept investigating the complaint of breaker tripping, PER customer would trip every 60 seconds,I had turned fridge ON and it had not tripped the entire time I was there 20 minutes or so Was going to the breaker to inspect if GFI breaker and thats when customer could not contain her anger any more She told me I had a tone since I walked IN, I advised her that the only thing I was doing is asking questions and that her information was crucial in providing a more accurate diagnosis Once she changed her demeanor and her being upset and a NOT comfortable with me being there I walked away. She got even more upset, she followed me to the truck taking video I waved bye bye and drove off Called JR and documented Called tech support and also documented SR#7740354936Per the brief time i was allowed to troubleshoot I was able to observe the compressor making this abnormal noise and could potentially trip the breaker Will order the seal system and see if TPB would pay for repairs and if so, it would have to be another tech as Im sure customer doers not want me back ; ordrng 1 W10507884 (Compressor) and 1 W11536253 (Evaporator) and 1 WPW10143759 (Drier)"

Needs LED module ; ordrng 1 W11470191 (LED Module)

"Replaced magnetron,transformer,diode,capacitor and thermostat"

Inspected fridge and found evaporator cover frozen solid Sent customer quote for repairsCustomer approved ; ordrng 1 W11087438 (Evaporator fan/thermistor) and 1 WPW10389152 (Fan support) and 1 WPW10248595 (Damper)

Diagnosed unit and found worn out rollers and pulley parts not t/s ordered; ordrng 1 WP691366 (Pulley) and 1 349241T (Rolllers) and 1 W10359269 (Support) and 1 341241 (Belt)

Diagnosed unit and found object stuck in pump removed ran and tested unit checks ok

Diagnosed unit and found bad connection at the power cord adjusted ran and tested unit checks ok

Diagnosed unit and found customer had unbalanced load ran and tested unit checks ok

Diagnosed unit and found connection issue at the ignitor adjusted unit checks ok

Replace bad sensor everything working OK now

Replace bad controls unit tested fine

Found unit working as designed customer needs to have main vent service

"Found no issues with washer, customer need main drained service"

Found door gasket needed some adjustment

Upon arrival i diagnosed unit. After inspection i ran unit. No leaks coming from unit. The leak was coming from under the sink by garbage disposal hose (picture attached). I let customer know that will be on customer to get replace. Unit is working as designed.

Upon arrival i removed unit and replaced drain pump. Reinstall and Tested unit after replacement everything passed tested ok. Unit is working as designed.

Upon arrival i diagnosed unit. After inspection top oven not working getting error code F1 control fault.Let customer know parts not available we can not service.

Upon arrival i diagnosed unit. Ran cycle heating element came on. I showed customer heating element steam coming from heating element when sprinkled with water. Unit did not have Rinse aid. I advised customer about rinse aid and how to use it. Unit is working as designed.

"Upon arrival, i diagnosed unit. After inspection, gaps between unit and cabinetry are normal. The unit was not working properly. I did a reset on control ui and made sure it had correct model serial software. Tested unit afterward (pictures attached). Tested ok passed. The customer tested as well. Unit is working as designed."

"Upon arrival, I inspected the unit. It had a bin full of ice. The customer also had a few other issues. I called Techline. The unit is working as designed. I was told that the extended freeze should go away after the temperature was adjusted. If not, the control board needs to be replaced. SR774035212; ordrng 1 W11574766 (Panel ui) and 1 W11574767 (Panel ui) and 1 W11664342 (Control board)"

"Upon arrival, I inspected the unit and found that the suspension needed to be replaced.; ordrng 1 W11130362 (Suspension)"

Replaced main board

"Need additional parts ; ordrng 1 3392519 (Fuse, Thermal) and 1 W10900067 (Kit, Thermal Cut-Off) and 1 W10724237 (Element, Heater)"

Replaced defrost sensor

Reconnected sensor and checked all function

Needs W11352193 Flame Spreader and W11352195 Flame Spreader; ordrng 1 W11352195 (Flame Spreader) and 1 W11352193 (Flame Spreader)

Reconnected light socket

Replaced console

Reconnected main board and checked all function

Upon arrival and after replacing parts the unit still wasnt working. I then called Techline and after some test we noticed something is seizing the basket causing it to not read the correct rpm. Unfortunately the 30torque screw was stripped and will need special tools/bits to remove the screw. Will need a gear case also. Will need 2x labor and parts SR# 7740354694; ordrng 1 WPW10215093 (FILTER COVER) and 1 W11032711 (WASHER) and 1 W11393685 (GEARCASE) and 1 W10902814 (WASH PLATE) and 1 W10909670 (NUT SPANNER)

Upon arrival and after replacing the control board the cancel button is now working.

Upon arrival and after diagnosing I noticed a creature in the control board area. Per trade care we cant proceed. The source to the issue is the roaches touching the board.

checked and didnt find any problems all function worked and heated ok

replaced bad latch; used 1 W11307244 (LATCH) from stock

found and replaced shorted parts

"Ran diagnostics, corrected issue with wiring harness. All functions checked ok at this time"

Ran diagnostic ordering slide door to replace rusted ones; ordrng 1 W11658402 (Slide door)

"Upon arrival, I inspected the unit and found that the drive motor gasket and pulley need to be replaced.; ordrng 1 W10315848 (Drive motor) and 1 WP8540088C (Pulley) and 1 WP8540101 (Belt) and 1 WPW10202459 (Basket) and 1 WPW10111158 (Gasket)"

Did not have the correct part for this unit.; ordrng 1 W11460946 (Pump&Motor) and 1 W11678270 (Control board)

need stats; ordrng 1 w11344457 (htr) and 1 279973 (stat) and 1 w10693363 (stat) and 1 8577274 (stat)

needs guard; ordrng 2 357640 (screw)s and 1 w11087188 (guard)

found and replaced stalled part

Upon arrival unit has different issue than previous repair. This time unit needs bin thermistor. ; ordrng 1 WPW10511923 (Bin thermistor)

"Replaced pan, thermistor, and fan scroll. I also unclog drain line."

Will need ice maker ; ordrng 1 W10873791 (Ice maker)

Replaced faulty thermistor. Unit is now working as intended no issues at this time

Adjusted and reinstalled door latch all tested normal.

Need to order ; ordrng 1 W11745091 (Extension drain)

checked unit out took unit down checked unit at this point unit checked out dl number w1crv70nl2

replaced shorted hv diode and checked all operations. ck ok; used 1 W11256462 (DIODE) from stock

Upon arrival I replaced the panel u/i console and vent per Techline. Tough and normal buttons are currently now working.

Assisted Tech JPNo leaks detected.

Replaced locked compressor and checked operation ok

Unit was moved; O-emld tckt

Order motor ; ordrng 1 W11441128 (Motor)

Replaced damaged fan assembly.

Per Techline control needs to be replaced. SR#7740354042; ordrng 1 W11353849 (Control) and 1 W11354922 (UI)

Ran diagnostics. Fixed gasket.

Fixed reservoir.

part order; ordrng 1 w11607637 (control)

cust got unit exchanged

assisted LV

"There are no part failures or error codes present. The tech support team has confirmed that the range is fully functional, and the chips in the liner do not pose any concerns regarding overall performance or safety - unit is working as normal SR#7740353971"

unit needs icemaker assembly ; ordrng 1 W10873791 (ICEMAKER)

Assisted Tech JP

"Replaced faulty valve, igniter and burner. Unit is now working as intended no issues at this time"

Could not replicate smell as unit was off. Spent time letting it run to try to replicate issue. Could not replicate smell. Customer to monitor unit over the next couple of days. Customer to call back if issue persists

Needs gas pressure tester. Please schedule after parts pickup so I can pick up tester from office ; ordrng 1 Xxxxx (Gas pressure tester)