Installed modules ran test all operations normal.

Reset power supply adjusted terminal connections also all operations normal.

Ordering parts ; ordrng 1 W11620481 (Control)

"Found MOTOR, EVAPORATOR FAN (INCLUDES WIRE HARNESS bad; ordrng 1 W11457241 (MOTOR, EVAPORATOR FAN (INCLUDES WIRE HARNESS)"

Need Erc and igniter ; ordrng 1 W11620481 (Erc) and 1 W11590294 (Igniter)

Replaced leaking inlet water valve assy. Operations are correct now

Replaced ice bucket and coupling unit is ok

checked unit out fixed floor of unit unit is correct now

Check unit and tighten loose screw at stater and motor. Unit is now working as design.

Reconnected the front control dispenser assembly

"Replaced harness and control, now heating normally"

Replaced warped dispenser motor all functions normal

"Advised customer of door replacement to resolve water line issue, customer declined repairs, estimate provided; ordrng 1 LW11038922 (Freezer door)"

"Replaced warped freezer door, all functions normal"

Order latch and control; ordrng 1 W11307244 (Latch) and 1 W11603810 (Control) and 1 W11652038 (Harness) and 1 W11428524 (Capacitor)

Replace compressor unit is cooling properly now

Replace part unit tested properly

replaced shorted ui panel and control board and checked operations. ck ok

Checked unit spark module not responding checked for damage wire harness no damage was found an gas valve does not lower flame down properly ; ordrng 1 W10860916 (Spark module) and 1 W11109973 (Value) and 1 W11685628 (Control)

Unit has multiple error codes; ordrng 1 W10448876 (Pressure switch) and 1 W10443885 (Door lock) and 1 W10599356 (Valve) and 1 W11201274 (Board)

"Ran diagnostic, connected loose connection at main coil. Ran temperature to 350 degrees. All unit functions now checked ok."

Replace defective control unit is OK

"Ran diagnostics, documented findings with techline. Ordering complete freezer door; ordrng 1 W11633128 (Door)"

Check unit unit to find garbage disposal does not have an air gap customer was informed to hire a plumber to punch out disposal and it is OK

Check unit to find no frost buildup in freezer nor is there any mechanical failure with this unit technician heated freezer door gasket to get a better seal did not allow unit to condensate unit is OK

found and replaced shorted cnt and cycled

"order parts 3wgt; ordrng 1 W10309988 (compressor) and 1 WPW10143759 (dryer) and 1 WP2188874 (condenser fan motor) and 1 W11193484 (blade-fan) and 1 w11506635 (coupling) and 1 4389144 (motor,evap.fan) and 1 WPW10583800 (thermostat)"

Customer need to approve door assembly W11026425 Stainless caused the line freezing ; saved tckt

"Ran diagnostic, adjusted vent for proper ventilation. All unit functions checked ok at this time. Customer advised on distance of vent duct maybe the main cause of poor drying and error codes."

"Ran diagnostic, adjusted air gap at manifold. All unit functions checked ok. Customer advised on using vent when oven is in use."

Check unit to find all operations working as design technician adjusted bracket on fan motor unit is OK

"ice build up on freezer back panel - unit needs damper control, thermistor defrost heater & harness ; ordrng 1 W11087463 (DAMPER) and 1 WPW10487766 (HARNS-WIRE) and 1 WPW10384183 (THERMISTOR) and 1 WPW10436849 (HEATER)"

"ran diagnostics, ran test cycle - no error codes - unit working as normal"

Control board is not responsive - removed back cover and found roaches infestation. Warranty will not cover repair due to user care neglect.

"Ran diagnostics, replaced complete evaporator cover and control assembly per service pointer. All functions checked ok at this time"

Checked unit called tech on hold for 30 minutes switch to turn oven on clicking all the time ; ordrng 1 WP9762215 (Oven switch) and 1 W11182108 (Bake element)

"Ran diagnostic, cleared condenser coils. Customer advised on icemaker functions without water may cause noise and not over stacking refrigerator"

"Ran diagnostic, tested all components. All unit function checked ok. Customer advised on Voltage issue."

Unable to contact customer ; O-emld tckt

Ran diagnostic 2with techline Sr-7739671361. Recommended full seal system repair. Due to unavailability of lower unit part. Heater drip pan 2259329. Unit is unserviceable.

"Ran diagnostic ordering replacement Console and Drain pump. Update phn,8326406941; ordrng 1 W11412291 (Drain pump) and 1 W11660284 (Console assembly)"

"Ran diagnostics, ordering complete gearcase splutch and actuator assembly ; ordrng 1 W11449840 (Gearcase) and 1 W11481722 (Actuator) and 1 W10721967 (Splutch)"

Check unit to find a wobbled out screw from the stater technician tight screw and checked operations. Unit is no longer making noises during spin cycle. Unit is OK.

replaced broken cam and ran test cycle. all test ok; used 1 W10721967 (CAM) from stock

Replaced complete tub and basket assembly in unit. All functions checked ok at this time

replaced shorted control board and control panel and checked all operations. ck ok

replaced faulty thermostat and checked all operations. ck ok; used 1 WP3387134 (THERMISTOR) from stock

Att. LL and Elsa already replaced 4 times and continue to get wrong control panel. Elsa is checking with parts research; ordrng 1 W11598199 (control panel)

replaced faulty control panel and control board and ran test cycle. test ok

"I replaced the motor and shafts, unit checked ok"

need mtr; ordrng 1 w10396029 and 1 694089

replaced locked pump/motor and shorted control board and ran test cycle. test ok; used 1 W11087226 (CNTRL-ELEC) from stock

Needs console and lower spray arm ; ordrng 1 W11612307 (Console) and 1 WPW10491331 (Spray arm)

Inspected MW and a found it shorted out Sent customer quote for repairs

checked unit out unit was infested with roaches called tpss talked with diane unit void at this point ref 7739598441

"Checked unit and fitting from bottom of the door were leaking, I replaced them and checked ok; used 2 W10277958 (Fitting) from stock"

"Checked unit and the water lines are frozen, customer said they are going to defrost the unit, I also explained to customer they need to use a bypass if they don't want to use a water filter"

"Need W11348063 Control, Electronic; ordrng 1 W11348063 (Control, Electronic)"

"2 man helper, seal system repair"

Reset the system to factory and reconnected front control

Replaced pum

"Retighted the fanblad , checked all function"

Reconnected motor

Upon arrival the garage where builder has all doors didn't have a left freezer door. ; ordrng 1 W11435344 (Freezer door)

order parts 4wgt; ordrng 1 W11580057 (compressor) and 1 W11109499 (drier-tube) and 1 W11546692 (evaporator) and 1 W11504449 (coupling) and 1 W11506619 (coupling)

replaced broken outer door glass and nameplate and checked operation. ck ok

checked unit out fixed guss fitting put new one on door conection unit is correct at this point

Uninstalled unit replaced faulty thermistor ran test all operations normal.

Ordering parts ; ordrng 1 Wp2254618 (Hinge) and 1 Wp2254473 (Hinge)

Checked unit and reattached front right upper leveling screw that was not in front right leveler and adjusted right upper door hinge. Unit checks ok.

Call tech line sr# 7739666599

Checked unit and replaced shorted diode. Ran several test cycles and unit checks ok.; used 1 W11256462 (DIODE) from stock

Checked unit for gas leak and none found. Customer advise only smells gas during use of oven. Advised customer and demonstrated how the burner ignites and cycles and they would have a gas smell each time the unit cycles. Also advised to run the exhaust fan on low when oven is in use. Unit checks ok.

part order; ordrng 1 w11452196 (harness)

Found breaker tripping when oven is preheating. Removed ground wire from terminal block. Heated bake element at 500 degrees for 30 minutes. Reinstalled ground wire and tested

Found power cord not pushed into outlet completely. Reattached power cord and raised drain hose for proper drainage.

Found breaker tripping when oven is preheating. Removed ground wire from back of unit. Heated bake element to 500 degrees for 30 minutes. Reinstalled ground wire and checked operation

No error code detected. Removed power from unit and restored power. Checked operation and unit is working fine

Ordering parts for unit.; ordrng 1 W11607637 (Control Board) and 1 W10721967 (Cam) and 1 W11481722 (Actuator) and 1 W11428524 (Capacitor) and 1 W11665967 (Harness)

Upon arrival I diagnosed unit. After inspection codes F2E1 F8E1 F1E1 F3E1 unit needs parts. Diagnostic cycle wouldn't start.; ordrng 1 W11607637 (Control Board) and 1 W11665967 (Harness Wire) and 1 W10919003 (Drain Pump)

checked unit out fixed bulkad unit is correct now

checked unit out at this point cust needs to defrost for 50 hours then unit will be correct unit ced out

"Checked unit and capacitor and diode are shorted out, and unit has cooking oil dripping everywhere, I showed the customer the conditions of the unit and explained to them because of the amount of oil the unit has it's a fire hazard, customer decided to replace the unit because of its condition"

"Checked unit and the unit has physical damage on the front left corner, I ran a diagnostic and unit had error code F8E1, so explained to Mr that was there at the home the problem, Mr, said that I would need to explain that to his sister, I talked to the sister over the phone and explained to her and she didn't understand my explanation or she didn't want to know, I asked her on how did the physical damage happened, she said that happened recently when they moved from one home to another,, and it wasn't there fault that it happened, so I explained to her because of the damage the door is not sealing correctly, and it jumps everywhere when it open and close, the dispenser doesn't go all the way in and that the tub is broken, and when the unit spins it jumps everywhere because the cabinet is not aligned, so after explaining to her several times, the husband came to the home, and I had to explain to him all over again , and he was the same way they didn't want to listen, Mr. said that the water leak had nothing to do with the physical damage, Mr, said if I didn't want to do my job, then what the hell i was doing in their house, and that this point I had three people screaming at me and calling me names, so I called partner team and documented with them, and they said because of the physical damage they would not cover the repair, and to refer the customer to contact customer service, and notes would be attached to file we already have"

Need to order; ordrng 1 W11400156 (Suspension)

Replaced heater and UI

Replaced icemaker and inlet water valve assembly. Operations are correct now

Replaced both elements & burned unit at 500.

"Unit rebooted , operations are correct now"

Unit was off temp 79 degrees. rebooted unit. Let unit run for 2 hrs came back to check unit. Temp was 10 degrees. Unit working at this time. Customer to monitor unit.

Removed hung cube from harvest fingers of icemaker. Operations are correct now

asisted je unit checked out

"Ran diagnostic didn't find any error codes, ran diagnostic cycle didn't find any leaks. I then filled basket and didnt find any active water leaks."

"Replaced shorted igniter, all functions normal"

Checked unit and repaired loose connection at thermal cut off. Ran test cycle and unit checks ok. Advised customer to have vent cleaned from wall to exit from house.

Checked unit and replaced misformed icemaker cover. Unit checks ok.

"Checked unit and replaced shorted control, stator,slider and clutch. Ran auto test cycle and unit checks ok."

Order parts reschedule with customer; ordrng 1 w11620483 (GLASS-DOOR)

Checked unit and replaced blower motor with out of balance wheel. Ran test cycle and unit checks ok. Advised customer the air damper is loose and to contact installer. Assisted by Tech JP.Talked to Andrea at Trade Partners and issued AUTH# w1bxi90nl2

checked unit out unit needs compresser and evap cust looking at new unit